Skene Design

Intelligent Lights for the Intelligent RiderTM


P3 Lights Programming

P3 Lights can quickly and easily be programmed to any of several modes simply by using the brake lever. There is no need to cut wires or fiddle with tiny switches.

When the ignition is switched on, a programming window is enabled for 5 seconds. Activate the brake a given number of times within this time period, and your P3 Lights are reprogrammed! The end of the programming window is indicated by a brief flash of the lights. Do not activate the brake again until you see this flash. The brake flash sequence and tail light modulation modes are programmed independently, and remain in the selected mode when the ignition is switched off.

Programming Details

To program P3 Lights, turn on the ignition. Within 5 seconds, activate the brake the following number of times, then wait for the brief flash to signal the end of the programming window:

BRAKE LIGHT PROGRAMMING
  • 4 - steady brake light
  • 5 - brake switches between low and high brightness 4 times *
  • 6 - brake switches rapidly between low and high brightness 4 times,
    then more slowly 4 times, then goes steady (default setting)
EMERGENCY FLASHER
  • 7 - medium repeating flash
  • 8 - rapid repeating flash
  • 9 - quad flash

Note: i. emergency flasher is disabled upon application of brake ii. emergency mode is saved on power off. This allows you to switch your motorcycle to parking light mode and remove the key, without disabling the emergency flasher.

TAIL LIGHT MODES

  • 10 - toggles tail light modulation (flicker) ON/OFF* (default is ON)
  • 12 - toggles high brightness tail light ON/OFF (default is OFF)
  • (for poor weather conditions such as heavy rain or fog)

* Depending upon local regulations, the user may want to disable tail light and brake light modulation.


© 2009 Skene Design, LLC